Manually Park The Shuttle - Canon Oce BLM550+ Operation Manual

Manually park the Shuttle

Manually park the Shuttle
When to do
The error messages 'MANUALLY PARK SHUTTLE' and 'SHUTTLE NOT PARKED' are displayed.
Illustration
[39] Shuttle Assembly Position - CORRECT
[40] Pick-up fingers
1 Pick-up fingers
Step
1
2
3
4
102 Chapter 6 - Error Conditions, Problems and Solutions
B
A
Open the folder cover.
Push the shuttle-assembly to the
end.
Wait until the error message SHUT‐
TLE NOT PARKED is cleared from the
screen.
Close the folder cover.
1
See
page 45
The illustration above shows the correct
position for the shuttle assembly. Screw
'A' must be aligned with white gear 'B'.
If the shuttle assembly does not move to
the correct position, push the pick-up fin-
gers away from each other by 2-3 mm
and try again. Repeat if necessary.
See illustration above.
If the message does not clear, check that
the shuttle assembly is in the correct posi-
tion. Repeat Step 2 if necessary.
Open and Close the Folder Cover on