Change The Fuses Of The Booklet Maker - Canon Oce BLM550+ Operation Manual

Change the fuses of the Booklet Maker

Introduction
The Booklet Maker has 2 fuses located at the mains power input (see
Booklet maker on page
Required tools
Fuse description: 7A, HRC Quick Acting, F
IMPORTANT
Turn OFF the machine and remove the mains power supply cable before you change the fuses.
This machine uses two fuses in parallel. To avoid the risk of fire, replace fuses using only the
same type and rating.
Procedure
1. Turn OFF the Booklet maker.
2. Disconnect the Booklet maker from the power supply.
3.
Turn one fuse-holder to the left and remove the fuse-holder from the Booklet maker.
4.
Check the fuse.
5.
If the fuse is blown, then replace with a fuse of the correct specification.
6.
Repeat the procedure for the other fuse.
NOTE
If the fuse blows again, call your service engineer.
14). If either fuse is blown, the Booklet maker will not operate.
Change the fuses of the Booklet Maker
Chapter 6 - Error Conditions, Problems and Solutions
The Rear Panel of the
101