Table of Contents
Advertisement
7. Attach the SW-1106 board.
(1) Connect the harness (HP-SW) of the supplied
accessories to the connectors CN4 on the HP-101
board and CN2 on the SW-1106 board.
(2) Connect the harness (12 pin) disconnected in (3)
of step 5 to the connector CN1 on the SW-1106
board.
(3) Attach the SW-1106 board using the two screws.
Harness (12 pin)
SW-1106 board
2 pin
CN1
connector
CN2
BVTT3 x 6
BKMW-E3000
HP-101 board
CN4
Harness (HP-SW)
(Supplied accessory)
9 pin
connector
8. Twist the harness (HP-SW) several times, and route it
as shown in the figure. And then connect the 9 pin
connector to the connector CN1 on the LED-357
board.
n
Tuck the harness to the SW-1106 board to get it out of
the way of switch operation.
Tuck the harness.
CN1
Twist
Harness (HP-SW)
LED-357 board
9 pin connector
9. Attach the front panel (E) and the upper lid (front)
assembly to the VTR in the reverse order from steps 1
and 2.
n
When attaching the front panel (E), hook the two
hooks at the bottom of the front panel to the convex
portions of the chassis.
PSW3 x 6
CN1
LED-357 board
SW-1106 board
Hook
Front panel (E)
Hook
PSW
3 x 6
1-17 (E)
Advertisement
Table of Contents
