Table of Contents
Advertisement
Troubleshooting
If the display appears as shown above, check the following:
• Is the Ethernet cable securely connected to the LAN connector for development on the unit?
• Is the Ethernet cable securely connected to the hub?
• Is the Ethernet cable securely connected to the host PC?
• Do the network settings of the host PC match those of the unit?
After checking the above items, start the ping command from the host PC. Then check the
indicators located near the LAN connector for development on the unit rear.
The unit cannot be accessed, even though five minutes have elapsed since it was
turned on.
t Check that the power indicator lights up in green.
If so,
There may be a problem with the Ethernet cable or the connected hub. Change the Ethernet cable or
hub, or contact your network administrator for assistance.
Status indicator is flashing red.
t If the status indicator (t page 13) is flashing red, there may be a system malfunction or the
unit's internal temperature may be too high. Wait a while and then press the reset button or turn
off the unit once using the main power switch, and then turn the unit back on.
If the status indicator flashes frequently, it may be an indication of a malfunction in the unit. In this
case, contact your sales representative.
The unit does not function properly when using storage media.
t For information on problems related to Memory Stick™ media, CompactFlash® or SD Memory
Card use, contact the manufacturer from where you obtained the media.
33
Troubleshooting
Advertisement
Table of Contents
