Table of Contents
Advertisement
Attaching the unit to the rack
Installation
Caution
• The unit should be installed into the rack mount by two or more persons. The unit must be firmly supported when it is placed onto
the rails. If not, an injury or accident could result. Take care not to catch your fingers between a stopper and a rail.
• Pay attention to elevations in the unit's internal temperature. For information on operating conditions, see "Specifications"
(t page 34).
• Position the unit so that there is at least 10 cm (3.94 in) of space behind the vents on the unit rear to prevent anything from blocking
the vents. Arrange the cables so that they do not block the vents. Also, if using a rack that has a front cover, check that the flow of
air into the unit's vents is not blocked.
• Regularly clean the filter unit (t page 31).
• When installing the rack or unit, secure all necessary parts and components and perform work under stable conditions.
• Connect the supplied AC power cord to power sources that use the appropriate capacity and protective circuitry. For information
on power capacity, refer to the label on the unit.
• Connect all AC power cords used by the devices within the rack to power strip(s).
1 Attaching the inner rails to the unit
1
Remove the feet and screws from the
bottom of the unit.
Retain them for possible future use.
2
While pressing down the stopper, pull
out the inner rail from the rail A.
Outer
rail
A
Bottom side
Stopper
Inner rail
3
Attach the inner rails to both sides of the
unit using the screws E.
Top side
4
Attach the handles B to both sides of
the unit using the screws E .
Attaching the unit to the rack
19
Advertisement
Table of Contents
