Table of Contents
Advertisement
Setting up with the administration tool
Update of CP
Upon clicking "Update of CP", the following
screen is displayed. This screen is used to update
the software required by the communication
processors.
1
Place the file for updating in the
appropriate directory on the host PC,
and click "Update of CP".
The following screen appears.
Caution
Upon clicking "Setting confirmation" (see the step below),
the version of the file that is already installed and that of the
update file are checked to confirm whether the update file is
more recent and to confirm the dependency relationships
between them.
This check is not performed if "No version checking" is
selected. It is recommended that the default setting ("Check
versions") be used.
2
Enter the path to the file, and click
"Setting confirmation".
The following screen is displayed, and the
contents of the update file are displayed.
3
Verify the contents of the file, and click
"Setting".
The installation will begin.
If the contents are incorrect, click "Back" to
make corrections.
Restart of dtnetm
"dtnetm" is a program used to communicate
between the unit and development host PC via the
DECI protocol.
Upon clicking "Restart of dtnetm", the following
screen is displayed.
Click "Restart" to restart dtnetm and display the
restart status. After completing the restart, the
following screen is displayed.
Setting up with the administration tool
29
Advertisement
Table of Contents
