Toshiba Strata DK 16 Installation And Maintenance Manual page 313

REMOTE CALLING STATION MESSAGING (ADD/CHANGE)
STEP
1 Enter the Message Mode
At the >MODE prompt, enter M E S G CR.
2 To Add a Message
Set the terminal keyboard to lower case (caps lock off) and
enter m 9 7.
NOTE:
Enter "m" at anytime it is desired to start over in this procedure.
3 Enter X X X (XXX = station number for which the message will
be set and stored).
Enter: p
4 (p = page command and
= 2-digit message memory location: 10 ~ 19 personal
messages and 60 ~ 99 = system messages).
NOTE:
To store system message change permanently, DKT or EKT XXX
must be station assigned to port 00.
5 To Add a Message
Set the terminal keyboard to upper case and enter message
(alphanumeric, 32 characters max.). New message displays as
it is entered.
6 To Set the Message on the DKT/EKT LCD
Set the terminal keyboard to lower case and enter p m 0.
7 To Exit the Message Mode
At any time, enter m 0 q (lower case).
NOTES:
1. To cancel a message set via Mode 95, use Mode 97 with any message number in step 4 and skip
step 5.
2. [M] represents the message entered.
3. DKT = digital telephone; EKT = electronic telephone.
REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
TABLE RM-BP
MODE 97
ACTION
(or change a previously stored message)
-63-
SECTION 100-816-600
MARCH 1993
DISPLAY/PRINTOUT
>MODE MESG
m 97
m97 XXX
m97 XXX p
m97 XXX p [M]
m97 XXX p [M] p
m 0
Zero
m 0
q
>MODE