Toshiba Strata DK 16 Installation And Maintenance Manual page 301

STEP
Enter Program Mode
1
At the >MODE prompt, enter P R O G CR.
2 Enter Program Number 50
Press CR.
3 Enter the number 2. The system will display the last area code
programmed. Refer to the System Record Sheet and change
if required.
4 To Exit Program/Store Data
A) To store data, press CR.
To exit this program, press # # CR.
B)
STEP
1 Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 Enter Program Number 50
Press CR.
3 Refer to the System Record Sheet and enter 31 ~ 35 as required.
Example: 31, enter 3 1.
System will display previously programmed number. Refer to the
System Record Sheet and change if required.
4 To Exit Program/Store Data
To store data, press CR.
A)
B) Continue returning to step 3 until all data for this program has
been entered.
C) To exit this program, press # # CR.
REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
TABLE RM-AY
PROGRAM 50-2
LCR HOME AREA CODE
ACTION
TABLE RM-AZ
PROGRAM 50-31 ~ 35
LCR SPECIAL CODES
ACTION
-51-
SECTION 100-816-600
MARCH 1993
DISPLAY/PRINTOUT
>MODE PROG
P
P 50
P50
P50 2 NNN
P50 2 NNN
P50 ##
P
DISPLAY/PRINTOUT
>MODE PROG
P
P 50
P50
P50 31 NNNN
P50 31 NNNN
P50 ##
P