Toshiba V Series User Manual page 80

Chapter 1 Overview
1
64
(11)Click the button <Connect (C)> to register the controller.
The result of the registration will be as shown below.
Figure 1-36 Connection Configuration Diagram (LAN Configuration)
(12)Execute [File (F)] and [Save (S)] to save the information registered.
(13)Confirm the current EN5 module information.
First, connect the Engineering Tool to the EN5 module serial communication port
(TOOL), and take out the information.
Set transmission parameters using [Options (O)] and [Set Transmission Parameters
(T)] on the Configuration Editor [Hardware Configuration] screen for Controller A.
Check the set parameters using the serial communication port.
Register the following: Means of transmission: RS-232C; port: COM1 (Specify the
port to be used. In this case, COM1.); network system: EtherLAN (0); timeout: 5
seconds; IP Address: 192.0.0.1. Then click [OK].
Figure 1-37
model 1000 Loop Controller L1 User's Manual - Basic Hardware