Connecting To The Internet - Sony NBS-CN110 Operating Instructions Manual

Connecting to the Internet

Note
In this case, use PCWA-
A100 for your Access
Point.
z Tip
The icon may appear as
or .
Notes
• The Access Point is
configured with the
manual connection
mode at the time of
shipment. Clicking To
Connect initiates the
dial-up connection.
• Note that automatic
disconnection may not
work due to
unexpected packets
sent from the Internet.
Click Disconnect to
disconnect the
connection when you
are through with the
Internet access.
When you are through with all settings described in
"Setting up the connection environment" on page 56,
you can connect to the Internet.
Phone Connection:
1
Double-click the reception level indicator icon
on the task tray.
2
Click To Connect.
Connection to the Internet service provider is
established.
3
Launch your Web browser.
A home page is displayed.
4
Click To Disconnect.
The dial-up connection is disconnected.
z Tips
• When the Access Point is in the automatic connection
mode, starting an e-mail or browser application causes a
dial-up attempt to be made. To place the Access Point in
the automatic connection mode, use the Custom Setup
Utility. For more information, see the Custom Access Point
Setup Utility Help.
• The Access Point does not automatically disconnect a
connection to the Internet when an e-mail or browser
application is closed on a single computer in order to allow
multiple computers to have simultaneous Internet access.
Thus, to disconnect the dial-up connection, you must
follow the steps above.
With the factory default setting, the connection is
automatically terminated after two minutes.
You can change the automatic disconnection time by
changing the Hangup After setting.
65