Chapter 3 Input/Output Terminals (Input/Output Ports); Attaching Wires To The Terminal Blocks - Panasonic MICRO-IMAGECHECKER A200 Series Hardware Manual

A200/A100 Hardware
3.1

Attaching Wires to the Terminal Blocks

Body
About Terminal Blocks
The I/O terminal block plugs into the controller, and the terminals are fastened by
tightening the screws.
Use the fittings and cable listed in the tables below.
Terminal block socket
Screw−on fittings
Phoenix Contact
Socket for attaching
terminal block t i l bl k
Wiring Method
1. Remove the wire shield.
Using Terminal Blocks Correctly
− Attach wires and attach or remove the terminal block only when the power is OFF.
− Do not use soldered wires. Vibrations may cause breakage.
Terminal
block
Cable
Manufacturer
Panasonic Electric Works Co., Ltd. ANMA8001
Phoenix Contact
Manufacturer Conductor
surface area
(cross−section)
SZS0.4 × 2.5
g Size
AWG#24 to 16
2. Insert the wire into a terminal
block hole until it stops. Turn
the screw.
Input/Output Terminals (Input/Output Ports)
3.1

Attaching Wires to the Terminal Blocks

Output terminal block
Input and power
terminal block
Part contact model number
Model number
MC1.5/16−ST−3.5
Conductor
surface area
(cross−section)
0.4 × 2.5mm
Conductor surface area (cross−section)
2
0.3 to 1.25mm
3. When connecting two or more wires,
twist them together before inserting.
Part order number
1840502
Screw torque
2
0.25N . m or less
3 − 3