3Controls, Indicators and
Connector Pin Assignments
Introduction
This chapter provides details of controls, indicators as well as connector
pin assignments for all connectors on the Gigabit Ethernet/82543 PMC
Module. The following connectors on the Gigabit Ethernet/82543 PMC
Module, are described:
Bezel Connector and LEDs
Figure 3-1 on page 3-2
bezel.
J1 and J2 PCI Bus Connectors on page 3-3
J3 PCI Bus Connector on page 3-7
RJ-45 Ethernet Connector on page 3-9
Cross-Over Cable Connector (10/100 Mb/s Only) on page 3-10
Loopback Connector (10/100 Mb/s Only) on page 3-11
shows the connector and LEDs on the PMC's front
Table 3-1 on page 3-2
describes these components.
3
3
3-1