Normal; Standard Parameter Set - HP 8112A Operating, Programming And Servicing Manual

Standard Parameter
Set
4-4 Operating
The Standard Parameter Set exists for two reasons:
•
If the instrument RAM becomes corrupted due to battery failure,
the Standard Parameter Set will be selected when the instrument is
switched on to give an error free display.
•
If an invalid combination of Operating and Control modes is
selected, switching the instrument off and on again, or selecting
RCL 0, will revert to the Standard Parameter Set. The Standard
Parameter Set is detailed below.
Trigger mode
Control mode
Burst
Period
Delay
Pulse width
Double pulse
Duty cycle
Leading edge
Trailing edge
High output level HIL
Low output level LOL
External input
Transition
Limit
Complement
Output Disable
NORM, PER, WID , DEL, illuminated
NORM

Normal

CTRL Off
0001 #
BUR
1.00 ms
PER
65 ns
DEL
100 µs
WID
200 µs
DBL
50%
DTY
10 ns
LEE
1 .00 v
10 ns
TRE
0.00 v
EXT INPUT Positive slope
Linear
LIMIT Off
COM PL Off
On
DISABLE
( )
active