Sony LMT-300 User Manual page 66

expire before continuing the output of the lamp will
have stabalized.
Countdown
Test Pattern
Timer
Setting
Cancel
Once the countdown has expired, click Next. Step
2 of 4 appears.
2
During this step you
initially adjust the Z
Axis for a maximum
indication on the
Projector Status Display
located in the upper-
right corner of the
projector's rear panel.
To adjust the Z-Axis, tap either the Plus
Minus button five times while observing the
reading on the Status Display. Adjust the Z Axis for an
average peak level.
Cancel
Note: There is a lag between when you tap either the
Plus or Minus button and the observation of a change
on the Status Display. Also, the readings you observe
may have some variation due to the way in which the
arc in the lamp moves slightly.
59
Theater Setup
Continue to adjust the Z-Axis by alternatively tapping
the Plus or Minus button until the value observed on
the Status Display is at a peak.
Lamp Power
Setting
Once the Z Axis adjustment
is complete, proceed to
adjust the X and Y Axis.
These adjustments are done
manually using a long 5mm
Allen key through an access
hole in the rear panel. Use
the Projector access key
open the Access Hole and
adjust the X and Y Axis by
observing the value on the Status Display. Adjust
about 1/2 turn and then observe the results. Continue
adjusting for peak reading. Refer to the Projector
Service Manual for additional information.
When complete click Next. Step 3 of 4 appears.
Next
3
During this step you optimize the Z Axis after
completing the X and Y Axis adjustments.
Adjust the Z-Axis. Alternately touch and hold the
Projector
Plus
Status
reading on the Status Display. Attempt to adjust the Z-
Display
Axis for an average peak level.
or
When complete click Next. Step 4 of 4 appears.
Next
1.The Projector Access Hole may not be locked in some
versions of the Auditorium Unit.
1
to
or Minus buttons while observing the
Cancel
Keylock
X/Y Axis
Adjust
Access
Hole
Next