Projector; Projector Control; Set Projector To On/Standby - Sony LMT-300 User Manual

Projector

Basic control of selected Projector system functions are
available from the Projectionist Terminal. In the
SRX-R320 based system, reference to the "Projector"
includes only the projector portion of the Auditorium Unit.
When the Projector is in STANDBY various subsystems
of the auditorium unit are still operational. To Shutdown
the Auditorium Unit refer to "Restart SMS Server" on
page 52.
Note: When the Projector is in STANDBY mode the
system remains active and accessible via either the
Projectionist Terminal or the SMS Controller application.
When the Auditorium Unit has been Shutdown you must
execute a Power ON sequence which is described in
"Restart SMS Server" on page 52.
The Projector menu
selection allows you to
access the information
and control functions
for the following areas.

• Projector Control

• Function Setup
• Projection Type
• Adjustment
• Ghostbuster
To access Projector
menus, tap Menu and
then tap Projector. The
Projector Menus
appear.
From PROJECTOR CONTROL you can place the
Projector system in STANDBY, return it to ON
(operational mode), turn off the LAMP, DOUSE the image
output, recall a preset configuration, and adjust the
Luminance Offset applied to the current presentation from
the Digital Cinema projection system.
From FUNCTION SETUP you can modify a limited
number of projector settings; Lamp Power, Zoom, Focus
and Electrical V Shift, and save these new settings to the
Current Function.
From Projection Type you designate whether the projector
is configure for 2D or 3D presentation.
From Adjustments you perform projector alignment
operations.
From Ghostbuster you can set Ghostbuster function
ON/OFF manually.
Tap Menu
Tap Projector
Projector Menu
Projector Control
The PROJECTOR
Tap Projector Control
CONTROL pane
contains basic controls in
addition to Current
Function select and the
Luminance Offset
control. To access
Projector Controls, tap
Menu, tap Projector and
then tap Projector
Control. The
PROJECTOR
CONTROL pane
appears.
Note: Changes made on
the PROJECTOR CONTROL pane effects the
presentation as soon as the selection is made.

Set Projector to ON/STANDBY

Using the STANDBY function insures that various
components of the Projector will shutdown in a orderly
manner and fans will continue to run so proper cooling of
the Projector is insured during the process.
CAUTION: DO NOT REMOVE AC-MAINS POWER
TO SHUT DOWN THE SYSTEM OR SET THE
PROJECTOR BREAKER TO OFF AS LAMP COOLING
WILL BE LOST AND THE RISK OF LAMP FAILURE
IS INCREASED.
STANDBY
POWER Group
3D Function
LAMP OFF
The following table provides a guide to the possible
Projector State/State transition possibilities.
Current Transition
Mode
STANDBY OK
NO
ON OK
Projector Menu
(Projector) ON
(Lamp) ON
LAMP ON
New Mode
ON
LAMP OFF
STANDBY
24
Projector