Device Configuration; Configuration Summary - Toshiba DP125F Operator's Manual

- DEVICE CONFIGURATION

Configuration Summary

This facsimile has many user
1
adjustable settings.
Each of these configuration set-
tings is discussed in detail
throughout the remainder of this
Press
section.
Screen displays.
Use the following procedures to
access one or more of these
configuration settings.
Press
SETTING. The Default Setting
sub-menu displays.
Enter the Configuration Menu
. The initial Menu
Press
SETTINGS. The Machine Set-
tings sub-menu will now dis-
plays.
1.COMM. OPTIONS
2.LISTS
3.INITIAL SETUP
01.SPEAKER VOLUME
4.DEFAULT SETTINGS
02.POWER SAVER
03.SEPARATOR PAGE
04.DEPARTMENT CODE
05.ACCOUNT CODE
06.PRINT DENSITY
to enter DEFAULT
07.DOCUMENT LENGTH
08.LINE MONITOR
09.RECEIVE INTERVAL
10.ECM
11.DOCUMENT MODE
1.MACHINE SETTINGS
12.COLLATE COPY
2.TX SETTINGS
13.LETTER HEAD PAPER
3.RX SETTINGS
14.REDIAL MODE
4.REPORTS & LIST
15.AUTO RECEIVE MODE
16.LINE-2 MODE
NOTE: Only 4 selections can
2
Select the Desired Configuration Setting (01-16)
Press
to enter MACHINE
highlighted or enter the desired Configuration Setting 01 through 16
from the list below. The detailed configuration procedure for each
setting is shown in parentheses after the configuration setting.
01. SPEAKER VOLUME - (Page 47) - Sets the Bell Ring, Alarm
Tone, Key Touch Tone and Monitor volume (0-7) (4*) for the
machine.
02. POWER SAVER - (Page 51) - Configures the machine's Super
Power Saver function for Automatic/Manual* or Off operation.
03. SEPARATOR PAGE - (Page 53) - Enables or Disables* a
FAX Separator Page, Copy Separator Page, and PC Separator
Page.
04. DEPARTMENT CODE - (Page 55) - Enables, Disables* and
Configures up to 99 Department Codes.
05. ACCOUNT CODE - (Page 58) - Enables or Disables* a 4-digit
Account Code entry.
06. PRINT DENSITY - (Page 59) - Sets the Print Density (-2-+2)
(0*) for the machine.
07. DOCUMENT LENGTH - (Page 60) - Enables* or Disables the
sending of documents longer than 1 Meter (39.4").
be displayed at one
time.
08. LINE MONITOR - (Page 61) - Enables or Disables* the Line
Monitor function.
09. RECEIVE INTERVAL - (Page 62) - Sets the interval (0-15
min.) the machine will wait after making four consecutive
dialings.
NOTE: * indicates the factory default setting.
10. ECM - (Page 63) - Enables or Disables* the ECM function.
or until the desired Configuration Setting is
45
45