Direct Transmission; Direct Transmission As Default Setting - Toshiba DP125F Operator's Manual

Direct Transmission

Direct Transmission is used if
there is not enough residual
memory or when a large num-
ber of document pages are to
be sent, etc.
1
This mode is also useful if the
operator wishes to visually con-
firm the actual transmission of
the document to the remote par- This procedure will discuss Di-
ty. rect Transmission when se-
lected as the default setting or
The documents will remain in
when Residual Memory has
the ADF and be transmitted one
been depleted.
by one.
Load the document face down
in the Document Tray (see
page 88).
Adjust the resolution and con-
trast if desired (see page 89).
Example of screen displayed
when Residual Memory has
been depleted:

Direct Transmission as Default Setting

2
Load the Document
Dial the facsimile number of the
remote party using any of the
four dialing methods.
•
•
•
•
MAY-17-00 WED11:49
RESIDUAL MEMORY 100%
• Press
ENTER TEL NUMBER
ror occurs.
Example of screen displayed
while a number is entered using
Keypad Dialing:
MAY-17-00 WED11:49 COMM. RESERVATION
RESIDUAL MEMORY 0% TEL NUMBER =(MAX128)
ENTER TEL NUMBER 0559761234
3
Dial the Facsimile Start Dialing
Number
Once the facsimile number is
entered, the dialing starts.
One Touch Key Dialing
... See page 97
FILE NBR =
Abbreviated Dialing
... See page 98
Alphabet Dialing
If the destination facsimile is
... See page 99
busy, the screen below is dis-
Keypad Dialing
played.
... See page 100
WAITING TO REDIAL
RESIDUAL MEMORY 100%
if a dialing er-
If the redial procedure is com-
pleted
screen below is displayed and
this transmission job is can-
celled.
MAY-17-00 WED11:59
LINE BUSY
4
Connect the Line to
the Remote Party
Once connected to the destina-
tion facsimile, the screen below
is displayed.
DIALING
025 FILE NBR =
0559761234
The remote party Terminal ID
will be displayed as shown be-
low.
FILE NBR =
+81 559 761234
without success, the
COMMUNICATING
025
0559761234
COMMUNICATING
025
103