Siemens SIMATIC HMI Series Operating Instructions Manual page 67

Extended mode from 5 m to 100 m distance
Connect an extended version or a PRO device for longer distances up to 100 m to the PC
via the Transceiver Unit and the following cables:
Connection of extended version or PRO device for Transceiver Unit
● A Cat. 6A Ethernet cable up to a maximum of 100 m in length
A direct connection via this cable is required, the connection cannot be extended via a
hub, switch or similar device.
Connection Transceiver Unit to the PC
● DisplayPort cable, length < 3 m
● USB cable, length < 3 m
ferrites
In extended mode, two ferrites are connected to the ends of the Cat. 6A Ethernet cable
required. Mount the two supplied ferrites according to the following figure on the Cat. 6A
Ethernet cable.
Mount the ferrites as close as possible to the connectors and in a position that allows the
Cat. 6A Ethernet cable enabled at strain relief plate, see section "Securing cables at the IFP
(Page 70)".
In extended mode, also note:
● The cable shield of the Cat. 6A Ethernet cable must be connected to the equipotential
bonding rail, see section "Connecting the equipotential bonding circuit (Page 60)".
● A ferrite is also required for the power supply lines, see section
"Connecting the power supply (Page 62)".
● If the Transceiver Unit is mounted on a standard mounting rail, then hold the
Transceiver Unit firmly at the top while connecting the plugs.
Wiring diagram
The following figure shows an example of the connection of an IFP1500 V2 extended via the
Transceiver Unit to an IPC427E and is generally valid for all extended versions and PRO
devices in connection with a corresponding PC.
* USB cable Type B connector - Type A connector
IFP V2, IFP V2 PRO
Operating Instructions, 08/2019, A5E46641410-AA
Installing and connecting the device
3.5 Connecting the device
67