Delivery Condition; Pcu Base Software Windows 7; Overview - Siemens SINUMERIK 840DE sl Commissioning Manual

Delivery condition

1.1

PCU Base Software Windows 7

1.1.1

Overview

The PCU-Basesoftware 50.5W7/IPC provides the basis for operating SINUMERIK software
(e.g. SINUMERIK Operate) on your SIEMENS PC system:
● SINUMERIK PCU 50.5
The PCU-Basesoftware is included in the PCU 50.5 scope of delivery and preinstalled.
However, for security reasons, the final installation and setup of user accounts must be
performed during the first startup.
An example flow diagram for initial startup is provided as an overview in Chapter Over‐
view (Page 15). This overview assumes that the PCU 50.5 is already installed and net‐
worked.
Information about the hardware configuration, installation, and networking of the PCU 50.5
is provided in the
Chapter
● SIMATIC IPC (only in the following configurations)
The industrial PCs SIMATIC IPC627D, IPC427D and IPC427E are compatible with the
PCU-Basesoftware in the following configurations:
● SIMATIC IPC627D configurations with the following article numbers:
● SIMATIC IPC427D configurations with the following article numbers:
● SIMATIC IPC427E configurations with the following article numbers:
● SIMATIC IPC477D configurations with the following article number:
● SIMATIC IPC477E configurations with the following article numbers:
PCU Base Software (IM10)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
SINUMERIK 840D sl Operator Components and Networking Manual ,
Operator panels .
– 6AG4131-2GM30-0BA6
– 6AG4131-2GM51-0BX6
– 6AG4140-0.C07-0HA0
– 6AG4140-6.H17-0HA0
– 6AG4141-1AA14-0FA0
– 6AG4141-5AB14-0FA0
– 6AV7240-0HC07-0HA0
– 6AV7241-3YA04-0FA0
– 6AV7241-3ZA04-0FA0
1
7