Faq- Why Configurations Are Lost When Using Save Configuration Command - Huawei MA5600 Manual

NGN Cases
Update Time: 2008-11-10 17:12:42
Views: 16
Author: w56146
Product Family: Broadband Access
Power System
Fault Type:
Keywords: H304ESC, Humidity sensor
Permission Level: 04Common Users Permission
Phenomenon Descr
Q:
iption:
How to connect and configure the humidify sensor in the H304ESC?
Alarm Informatio
None
n:
Cause Analysis: None
Handling Proces
A:
s:
As for hardware connection, the H304ESC provides many JTD interfaces and JTA interface.
Where, the JTD interface is used for connecting the digital parameter sensor, and the JTA interface
is used for connecting the analog parameter sensor.
In general, the humidity sensor is an analog parameter sensor. Therefore, it can be connected to
the JTA2 interface.
As for software configuration, see the Command Reference of the corresponding device. The
following shows an example of the command.
huawei(config-if-h304esc-0)#esc analog 6 40 80 0 100 sersor-type :1current unit H name
RoomHumidity
For how to select the analog parameter ID when running this command, see the Command
Reference of the corresponding device. For example, the Command Reference of the MA5600
provides the following description:
0: is the default inner analog parameter fixedly allocated to the temperature sensor by the system
and cannot be modified by the user.
1-4: are allocated to the voltage sensor by default.
1 indicates number 0 -48 V input.
2 indicates the first -48 V input.
3 indicates the second -48 V input.
4 indicates the third -48 V input.
5-8: are user-defined analog parameters for allocating to other extended analog sensors, such as
humidity sensor.
More information:
1. The H303ESC has a built-in humidity sensor. The built-in sensor is located in J5 of the board and
its analog parameter ID is 2. The H303ESC can also be connected to an external humidify sensor
and the connection and configuration methods are the same as what the preceding describes.
Without the built-in humidity sensor, the H304ESC is a simplified H303ESC and must be connected
to an external one.
2. The differences between the H304ESC and the H303ESC are that the LED of the H303ESC is
red and the LED of the H304ESC is green.

2.11 FAQ- Why configurations are lost when using save configuration command

Title: FAQ- Why configurations are lost when using save configuration command
ID: SE0000364112
Troubleshooting Cases
Information Type :
Update Time: 2008-12-23 10:44:56
Views: 16
Author: A.Rahman Alaa
Product Family: Broadband Access
34
Confidential Information of Huawei. No Spreading without Permission
Chapter 2 MA5600T (IP DSLAM) Cases
Product: SmartAX MA5600
Quality Level:
C
Product: SmartAX MA5600