Using QoS Classifiers To Configure Quality of Service for Outbound Traffic
2.
Configure the priorities for the DSCPs you want to use.
Figure 8-14. Assigning 802.1p Priorities to the Selected DSCPs
3.
Assign the DSCP policies to the selected device IP addresses and display
the result.
Figure 8-15. The Completed Device-Priority/Codepoint Configuration
The switch will now apply the DSCP policies in figure 8-14 to IPv4 packets
received on the switch with the specified IP addresses (source or destination).
This means the switch will:
Overwrite the original DSCPs in the selected packets with the new DSCPs
■
specified in the above policies.
■
Assign the 802.1p priorities in the above policies to the appropriate
packets.
Quality of Service (QoS): Managing Bandwidth More Effectively
DSCP Policies
Configured in this step.
8-35