Table of Contents
Advertisement
64/109
Bosch Rexroth AG
Pin Assignments of the IndraControl VEH 30.2
7.1.3
Pin Assignment IndraControl VAC 30.2
contact K1.3. Simultaneously, by opening contacts K1.1 and K1.2 the stop
circuit jumpering is deactivated. The stop circuits are active; the control is
ready to operate; the IndraControl VEH 30.2 is in operation and the stop
pushbutton is integrated in the stop circuit.
The time course of the connection procedure is illustrated in
course when connecting the IndraControl VEH 30.2 stop circuit" on page
64.
Active
Relay contacts
K1.1
K1.2
Inactive
Active
Stop button contacts
ST 1.1 ST 1.2
Inactive
Active
Stop circuits
Inactive
Fitting of the
connection cable
Fig.7-2:
Time course when connecting the IndraControl VEH 30.2 stop circuit
Fig.7-3:
Pin assignment of the IndraControl VEH 30.2 connection module
DOK-SUPPL*-VEH*30.2***-PR03-EN-P
Rexroth IndraControl VEH 30.2 Hand-Held Terminal
Relay switched
Stop button circuit
connected
Screwing-in of the
17-pin connection plug
Contacting of the
Conacting of the
advancing pins
voltage supply
fig. 7-2 "Time
t
Operating status
Stop button active
Advertisement
Table of Contents
