Siemens SINUMERIK 840D sl Manual page 67

Pin Function Assignment recommendation
no.
4 Input
Digital input $A_IN[4]
Line contactor, feedback signal
5 Ground for pins 1 ... 4
6 Ground for pins 7, 8, 10, 11
7 Output Infeed operation (Line Module with
DRIVE-CLiQ connection)
Digital output $A_OUT[4]
8 Output Infeed ready to start (Line Module with
DRIVE-CLiQ connection)
Digital output $A_OUT[3]
9 Ground for pins 7, 8, 10, 11
10 Output Digital output $A_OUT[2]
Line contactor control
Input Bero 2 – zero mark substitute
2. OFF 2
11 Output Digital output $A_OUT[4]
Input Probe 2 Central Measuring (check that
MD13210 = 0!)
Probe 2 - distributed measurement
(control MD13210 = 1)
12 Ground for pins 7, 8, 10, 11
Guide for the SINUMERIK 840D sl machine configuring
Manual, 07/2006 Edition, 6FC5397-6CP10-0BA0
3.6 NCU 7x0 and NX1x Terminal Assignment
BICO source/sink
CU: r0722.7
CU: p2082[3]
LM : p0860
LM :r0863.0 CU: p0742
CU: p2091.3
LM : r0899.0 CU: p0743
CU: p2091.2
CU: p2091.1 CU: p0744
LM : r0863.1
CU: r 0722.14 Drive:
p0495 = 5
Drive: p0845
CU: p2091.0 CU: p0745
CU: p0680[1] = 6 Each drive
p489 [1,2,3]=0
CU: p0680[1] = 0 Each drive
p489 [1,2,3]=6
NCU/NX Terminal Assignment
Macro number
The macro does not
perform any BICO
interconnection; the
use of the function
requires
parameterization by
the user.
1
5
1
5
1/5
The macro does not
perform any BICO
interconnection; the
use of the function
requires
parameterization by
the user.
The macro does not
perform any BICO
interconnection; the
use of the function
requires
parameterization by
the user.
1/5
The macro does not
perform any BICO
interconnection; the
use of the function
requires
parameterization by
the user.
3-11