Circuit Manual Group =6 - Siemens SINUMERIK 840D sl Manual

7.8

Circuit Manual Group =6

7.8
A drive group without main contactor, however, with the system/drive-integrated safety
function of the SINUMERIK 840D sl; connection of the safety sensor technology / actuators
using ET200S.
● Power supply of the NCU 710 (=6.-K11)
● Control signals to the NCU 710; digital inputs and digital outputs using the data of the
● DRIVE-CLiQ connection to the power units
● PROFIBUS connection to the ET200S distributed peripherals (=6.-K82)
● Control signals to the ET200S distributed peripherals
● Supply and control of the Line Module, including the integration of the auxiliary contact of
● Supply and control of the Double Motor Module (=6.-Q61)
● Motor, holding brake and sensor system (motor-integrated sensor component)
● Constant motor outgoing feeder using ET200S "Standard" motor starter (=6.-Q86.1)
● Constant motor outgoing feeder using ET200S "Fail-safe" motor starter (=6.-Q95.1)
● Safety control with ET200S safe digital input modules (=6.-K92.1, -K93) and output
● Safe interface level for external signals (=6.-K132, -K134)
All sensor/actuator signals required for the safety function are connected to the fail-safe
modules of the ET200S peripherals (=6.-K92.1, -K93, -K94, -K95). All fail-safe signals are
linked using the system/drive-integrated safety function of the SINUMERIK 840D sl. External
safety relays or safety controllers are no longer required. An external control of the SH/SBC
function using the terminals on the NCU or on the Motor Modules is also not required but is
performed internally by the system.
Guide for the SINUMERIK 840D sl machine configuring
Manual, 07/2006 Edition, 6FC5397-6CP10-0BA0
standard macros
the main power switch
connection to the Motor Module
modules (=6.-K94)
Typical circuit diagrams
7.8 Circuit Manual Group =6
7-43