Rerecording The Time Code - Tc Insert Function - Sony 85P Operating Instructions Manual

Rerecording the Time Code — TC
Insert Function
The TC insert function makes it possible to use the
internal time code generator to rewrite time code and
user bits when the time code recorded on a tape is
discontinuous.
You can start recording time code from an initial value
which can be set freely. (See page 33.)
Notes
• Use a tape which is recorded in the DVCAM format.
(You cannot use the TC insert function with a tape
recorded in DV format.)
• The time code recording starts from the tape position
at which this unit was servo-locked. (From the
current tape position, there is about 3 seconds delay
at playback of normal speed or about 16 seconds
delay at playback of 4 times normal speed.) To start
time code recording at the current tape position, first
rewind the tape by the time needed to allow the unit
to be servo-locked before reaching the current tape
position.
• If you use a tape on which ClipLink log data is
recorded, the ClipLink log data will be lost.
SYNC PHASE SC PHASE MENU
MONITOR SELECT
TC PRESET
CH- CH- CH- CH-
1/2 3/4 1/3 2/4
MIX
1
Press the MENU button on the menu control panel.
SYSTEM MENU
SETUP MENU
AUTO FUNCTION
HOURS METER
Monitor screen
1
2,4
3,5
RESET(NO)
6
SET(YES)
6,8,9
Setup menu
Time counter display
2
Press the ≥ button to select "AUTO FUNCTION".
SYSTEM MENU
SETUP MENU
AUTO FUNCTION
HOURS METER
Monitor screen
3
Press the ÷ button.
This displays the items in the level 1 of the auto
mode execution menu.
AUTO FUNCTION MENU
QSDI DUBBING
TC INSERT
Monitor screen
4
Press the ≥ button to select "TC INSERT".
AUTO FUNCTION MENU
QSDI DUBBING
TC INSERT
Monitor screen
Chapter 3 Convenient Functions for Editing Operation
Auto func
Time counter display
QSDI DUB
Time counter display
TC insert
Time counter display
(Continued)
35