Sony RS-232C Interface Manual page 54

ROUTING : 43[H] 52[H] 4C[H] 31[H]-38[H] ('CRL1-8')
43[H] 52[H] 52[H] 31[H]-32[H] ('CRR1-2')
This command is used to set the routing for the OUTPUT channels.
Various setups can be memorized in the scene memories by specifying these scene Nos.
The commands that correspond to the respective channels are shown below.
CHANNEL
LINE OUTPUT 1
LINE OUTPUT 2
LINE OUTPUT 3
LINE OUTPUT 4
LINE OUTPUT 5
LINE OUTPUT 6
LINE OUTPUT 7
LINE OUTPUT 8
REC OUT 1
REC OUT 2
• Packet format
43[H] 52[H] 4C[H] 31[H] "parameter" 0D[H]
(In the case of LINE OUTPUT1)
• Parameter
The parameter consists of the 20 bytes all the time in the order as shown in the table below.
byte Parameter name
1st SCENE No.
2nd MIC1/WL1 LEVEL
3rd MIC2/WL2 LEVEL
4th MIC3 LEVEL
5th MIC4 LEVEL
6th MIC5/LINE1 LEVEL
7th MIC6/LINE2 LEVEL
8th LINE3 L LEVEL
9th LINE3 R LEVEL
10th LINE4 A-C,F L LEVEL
When you specify NONE (30[H] '0') as the scene No. in the 1st byte, you can establish the present setup.
At the same time, when you specify the scene No.(31[H] ('1') through 44[H] ('D')), parameters of the subsequent 2nd through 20th byte
are written in the scene memory.
For the method of setting the scene No., see the GROUP FADER command (pages 29 and 30).
Command
43[H] 52[H] 4C[H] 31[H] 'CRL1'
43[H] 52[H] 4C[H] 32[H] 'CRL2'
43[H] 52[H] 4C[H] 33[H] 'CRL3'
43[H] 52[H] 4C[H] 34[H] 'CRL4'
43[H] 52[H] 4C[H] 35[H] 'CRL5'
43[H] 52[H] 4C[H] 36[H] 'CRL6'
43[H] 52[H] 4C[H] 37[H] 'CRL7'
43[H] 52[H] 4C[H] 38[H] 'CRL8'
43[H] 52[H] 52[H] 31[H] 'CRR1'
43[H] 52[H] 52[H] 32[H] 'CRR2'
byte
11 th
12 th
13 th
14 th
15 th
16 th
17 th
18 th
19 th
20 th
Parameter name
LINE4 A-C,F R LEVEL
LINE4 D-E L LEVEL
LINE4 D-E R LEVEL
LINE4 D-E LS LEVEL
LINE4 D-E RS LEVEL
LINE4 D-E C LEVEL
LINE4 D-E SW LEVEL
MIC1/WL1-MIC6/LINE2 ON/OFF
LINE3-LINE4A-C ON/OFF
LINE4 D,E ON/OFF
– 54 –