Sony RS-232C Interface Manual page 52

• LINE3-4F machine type (1, 3, 5, 7, 9, 11 and 13th byte)
This command is used to set category of the Control S.
MACHINE TYPE
NONE 30[H] ('0')
DVD 31[H] ('1')
VTR1(Beta) 32[H] ('2')
VTR2(8mm) 33[H] ('3')
VTR3(VHS) 34[H] ('4')
VTR4(DV) 35[H] ('5')
MD 36[H] ('6')
CD 37[H] ('7')
CD-R 38[H] ('8')
Blu-ray Disc 39[H] ('9')
VTR(Inst.)
3A[H] (':')
Cassette Deck
3B[H] (';')
• LINE3-4F connection (2, 4, 6, 8, 10, 12 and 14th byte)
This command is used to set the output channel of the CONTROL S signal.
CHANNEL TYPE
1
2
3
4
• CONTROL S I/F TYPE (15th byte)
This command is used to set the connection type of the channels 1 to 4 of the CONTROL S OUTPUT terminal.
When you want to set the I/F type to WIRED, set the corresponding bit to 0. When you want to set the I/F type to IR, set the
corresponding bit to 1.
Bits 4 through 7 are fixed all the time.
bit7 bit6
0 1
• PJ CONTROL (16th byte)
This command is used to set ON/OFF of the REMOTE POWER ENABLE and selection of the PROJECTOR CONTROL terminal with
the 8-bit data.
When you want to set the REMOTE POWER ENABLE to ON, set bit 1 to 1. When you to set it to OFF, set bit 1 to 0.
Bit 0 (I/F) changes depending on the setup of the "Projector Protocol" described later.
Bits 2 through 7 are fixed all the time.
bit7 bit6
0 1
Supported firmware
version
1.00 and higher
1.00 and higher
1.00 and higher
1.00 and higher
1.00 and higher
1.00 and higher
1.00 and higher
1.00 and higher
1.00 and higher
1.30 and higher
1.30 and higher
1.30 and higher
4 0[H] '@') (
4 1[H] 'A') (
4 2[H] 'B') (
4 3[H] ( 'C')
bit5 bit4 bit3
0 0 CH4
CONNECTION
TYPE
bit5 bit4 bit3
0 0 0
bit2
CH3
CONNECTION
TYPE
bit2 bit1
0 REMOTE
POWER
ENABLE
– 52 –
bit1 bit0
CH2 CH1
CONNECTION CONNECTION
TYPE TYPE
bit0
I/F