Sony RS-232C Interface Manual page 46

• MASTER MUTING (6th byte)
This command is used to specify muting of the MASTER A and B with the 8-bit data.
When you want to set the MUTING status, set the corresponding bit to 1. When you want to cancel MUTING, set the corresponding bit
to 0.
Bit-2 to bit-7 are fixed all the time.
bit7 bit6
0 1
• GROUP FADER MUTING (7th byte)
This command is used to specify muting of the REMOTE1 to 6 with 8-bit data.
When you want to set the MUTING status, set the corresponding bit to 1. When you want to cancel MUTING, set the corresponding bit
to 0.
Bit-6 and bit-7 are fixed all the time.
bit7 bit6
0 1
• LINE4 SELECT (8th byte)
This command is used to specify the selection channel for the LINE4 SELECT.
CH
OFF 30[H] (
A 31[H] '1') (
B 32[H] '2') (
C 33[H] '3') (
D 34[H] '4') (
E 35[H] '5') (
F 36[H] '6') (
Example: When you want to write the following channels in the scene No.1 after setting MIC1/WL1-MIC4 in the MUTING status,
LINE OUTPUT7 and 8 in the MUTING status, other channels in the MUTING-released status and LINE4 SELECT in B.
43[H] 4D[H] 54[H] 53[H] 31[H] 4F[H] 40[H] 40[H] 43[H] 40[H] 40[H] 32[H] 0D[H]
(' C M T S 1 O @ @ C @ @ 2 CR')
MUTING/LINE4 SELECT PARAMETER REQUEST:
This command is used to read the muting setup of the respective input/output channels and GROUP FADER for each scene memory and to
read the LINE4 SELECT setup from the SRP-X700P.
• Packet format
52[H] 4D[H] 54[H] 53[H] "parameter" 0D[H]
• Parameter
Specify the scene No. of the scene memory that you want to read, as the parameter. Method to specify the scene No. is the same as that of
the MUTING/LINE4 SELECT command. See page 44.
• Return packet format
When communication with the SRP-X700P is established with success, the parameter is returned together with ACK (41[H] ('A')) in the
order shown below.
41[H] "parameter" 0D[H]
The parameter is the same as the 7 bytes of the MUTING/LINE4 SELECT command parameter from which the scene No. is exempted.
bit5 bit4
0 0
bit5 bit4
REMOTE6 REMOTE5 REMOTE4 REMOTE3 REMOTE2 REMOTE1
'0')
bit3 bit2 bit1
0 0 MASTER B MASTER A
bit3 bit2 bit1
52[H] 4D[H] 54[H] 53[H] ('RMTS')
– 46 –
bit0
bit0