AC Smart Controller Setup
1. Under the AC Smart "Settings" tab, find and click on "Installing".
2. Press on the "AC Smart[00]" tab, go to "Registration Status", and change the CH1
setting to "MODBUS_9600".
3. Click "Auto Search" to find the devices connected to the controller.
4. After the search is complete, click "Send All".
5. Units can be added by clicking "Add Unit", and then clicking on the buttons next to the
name(s) of the applicable devices. After all necessary units are selected, click "Apply".
6. Click "Send All" to finish adding the device(s).
Figure 67: Clicking "Auto Search" (Step 3).
Figure 69: Adding Units (Step 5).
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
Figure 65: Clicking "Installing" Under the AC
Smart "Settings" Tab (Step 1).
Figure 66: Changing CH1 Setting to "MOD-
BUS_9600" (Step 2).
Figure 68: Clicking "Send All" (Step 4).
Figure 70: Clicking "Send All" to Finish Adding Devices (Step 6).
CONTROLLER
AC Smart Setup
115