Table of Contents
Advertisement
4.4.2 Battery Charger Preparation/Installation
It is possible to use this charger either by laying on a level place or mounting on the wall.
1. Insert the DC connector of AC adaptor into the DC jack
of charger.
2. Pass the cable tie through either of the cable rings at the
side of charger, and make a loop with the cable tie.
3. Pass the DC cable through the loop of cable tie, and pull the
end of cable tie to fasten the DC cable to the cable ring.
4. Plug the AC adaptor into the AC outlet.
When Mounting the Charger on the Wall
IMPORTANT:
Securely clamp the DC cable to this battery charger and
screw the DC cable to the wall using the provided cable clamper.
1. Secure the provided mount bracket to the rear of charger
by fastening the provided screws (x4).
Recommended tightening torque: 0.78 N·m {8kgf·cm}
2. Secure the mount bracket to the wall by locally procured
screws (x5).
• Procure 5 mounting screws according to the material
of the installation area. In this case, wood screws and
nails should not be used.
Recommended screw: M4 x 25 mm
• Required pull-out capacity of a single screw/bolt is
118 N {12 kgf} or more.
• If a wall board is too weak to support the total weight,
the area shall be sufficiently reinforced.
Hide quick links:
Advertisement
Table of Contents
