Parts Replacement/Cleaning Procedure > Consumale Parts Requiring Periodic Replacement and Cleaning Points > Removing the Inserter electromagnetic clutch (upper)
Removing the Inserter torque limiter (lower)
4) Remove five screws to remove the transfer guide.
1) Remove the rear cover.
(Refer to:4-9)
2) Increase the top cover open/
close angle.
(Refer to:4-9)
3) Increase the middle guide
open/close angle.
(Refer to:4-10)
Removing the Inserter electromagnetic clutch (upper)
4) Remove one screw and one connector, and the remove the
1) Remove the rear cover.
(Refer to:4-9)
inserter electromagnetic clutch (upper)
2) Increase the top cover open/
close angle.
(Refer to:4-9)
3) Increase the middle guide open/
close angle.
(Refer to:4-10)
4
Parts Replacement/Cleaning Procedure > Consumale Parts Requiring Periodic Replacement and Cleaning Points > Removing the Inserter electromagnetic clutch (upper)
x5
F-4-42
F-4-42
.
x1
x1
F-4-44
F-4-44
5) Remove three E-rings, one gear, one parallel pin, two bearings,