5. Add ports, LAGs, and virtual pipes to their vNIC groups.
6. Save the configuration.
© Copyright Lenovo 2016
RS G8264(config)# vnic vnicgroup 1
RS G8264(vnicgroupconfig)# vlan 1000 (Specify the VLAN)
RS G8264(vnicgroupconfig)# member 1.1(Add vNIC pipes to the group)
RS G8264(vnicgroupconfig)# member 2.1
RS G8264(vnicgroupconfig)# port 4 (Add non‐vNIC port to the group)
RS G8264(vnicgroupconfig)# port 11
RS G8264(vnicgroupconfig)# failover (Enable vNIC failover for the group)
RS G8264(vnicgroupconfig)# enable
RS G8264(vnicgroupconfig)# exit
RS G8264(config)# vnic vnicgroup 2
RS G8264(vnicgroupconfig)# vlan 1774
RS G8264(vnicgroupconfig)# member 1.2
RS G8264(vnicgroupconfig)# member 2.2
RS G8264(vnicgroupconfig)# member 3.2
vNIC 3.2 is not enabled.
Confirm enabling vNIC3.2 [y/n]: y
RS G8264(vnicgroupconfig)# port 5
RS G8264(vnicgroupconfig)# trunk 1
RS G8264(vnicgroupconfig)# failover
RS G8264(vnicgroupconfig)# enable
RS G8264(vnicgroupconfig)# exit
Once VLAN 1000 and 1774 are configured for vNIC groups, they will not be
available for configuration in the regular VLAN menus
(RS G8264(config)# vlan <VLAN number>).
Note: vNICs are not supported simultaneously on the same switch ports as
VMready.
(Select vNIC group)
(Add uplink port to the group
(Enable the vNIC group)
Chapter 19: Virtual NICs
335