Yamaha YFM400FWA 2000 Assembly Manual page 4

NOTE:
Check the following items again when set up and predelivery service are completed.
A: INSTALLATION OF THE PARTS INCLUDED IN THE CRATE
Speedometer
Handlebar
Front brake master cylinder
Throttle housing
Rear brake cable
Rear brake switch
Horn switch (for GB, F, CH, Oceania)
Handlebar switch
Handlebar band (left)
Handlebar band (right)
Handlebar cover
Engine side cover
Fender
Fuel tank side panel
Steering shaft and handlebar holder
Master cylinder and handlebar
Front suspension and upper arm
Front wheel and wheel hub
Rear wheel and wheel hub
Rear axle and nut
Rear brake cable
Rear brake switch lead
Front brake hose
On command four-wheel drive switch lead
Throttle cable
Band
YFM400FWA(M) 2000
SET-UP AND PREDELIVERY CHECKLIST
B: TIGHTENING TORQUE OF EACH PART
C: ROUTING OF WIRE, CABLES, ETC.
Front suspension
Front wheel
Rear wheel (right)
Rear wheel (left)
Battery
Tool kit
Brake master cylinder cover
Protecter
Under guard
Auxiliary DC jack
Front carrier
Seat
Reflector (for CDN, GB, F, CH)
20Nm (2.0 m•kg, 14 ft•lb)
7Nm (0.7 m•kg, 5.1 ft•lb)
45 Nm (4.5 m•kg, 32 ft•lb)
55Nm (5.5 m•kg, 40 ft•lb)
55Nm (5.5 m•kg, 40 ft•lb)
150Nm (15 m•kg, 110 ft•lb)
Handlebar switch lead
Auxiliary DC jack lead
Battery
Battery negative lead
Battery positive lead