Tx Required In Interval; Cw Id Override; Send Cw Id To Ra; Cw Id On Channel Change - Kenwood TKR-750 Programming Reference Manual

6.3.7

TX Required in Interval

It can be enable to send a CW ID with the configured
interval. (Refer to 6.3.2 TX Interval Time.)
The CW ID is sent after the
configured interval timer expires only
Checked
when TKR-750/850/751/851
Range
transmitted.
The CW ID is sent with the interval
Unchecked
configured in the "TX Interval Time".
Default Unchecked
Note: "TX Required in Interval" function is not applicable when
sending the CW ID with the "CW ID On" function.
6.3.8

CW ID Override

It can send a CW ID with audio signal when the TX
Interval Time expires during transmission.
TX Interval Time.)
The CW ID is sent with an audio
Checked signal when the TX Interval Time
expires during transmission.
Range
The CW ID is sent after the
transmission ends when the TX
Unchecked
Interval Time expires during
transmission.
Default Unchecked
Note:
! When sending the CW ID configured as CW ID Override On, the
QT/DQT code configured to the channel is encoded regardless
of the Encode with QT/DQT configuration.

Encode with QT/DQT (CW ID).)

! The CW ID is not sent even when the CW ID On function is
enabled during transmission while CW ID Override is disabled.
6.3.9

Send CW ID to RA

A CW ID tone is sent to the front speaker and the RA
terminal located on the rear panel. It can use to monitor
and confirm by dispatcher.
Checked "Send CW ID to RA" is enable
Range
Unchecked "Send CW ID to RA" is disable
Default Unchecked
Note: The CW ID is only sent from the RA line when the channel is
in Simplex mode. In this case, the CW ID is not sent from
the speaker.

6.3.10 CW ID on Channel Change

Version: 1.01
It can transmit a CW ID when the channel is selected or
changed. The TKR-750/850/751/851 transmits a CW ID
regardless of the configuration of the CW Mod. Delay
Time and the TX Interval Time.
6.3.11 Encode with QT/DQT (CW ID)
It can encode a QT/DQT (Primary) code configured to
each channel while sending a CW ID.
(Refer to 6.3.2
Note: The TKR-750/850/751/851 sends the QT/DQT code
(Refer to 6.3.11
Field Programming Reference (FPRG)
CW ID is sent when the channel is
Checked
selected or changed.
Range
CW ID is not sent even when the
Unchecked
channel is selected or changed.
Default Unchecked
CW ID is transmitted with QT/DQT
Checked
(Primary) code of each channel.
Range
CW ID is transmitted without QT/
Unchecked DQT (Primary) code of each
channel.
Default Unchecked
configured to each channel when Encode with QT/DQT is
enabled, and it does not send the QT/DQT code when
Encode with QT/DQT is disabled. However, the new CW ID/
CW Message is sent in conjunction with the Encode with
QT/DQT configuration when the TKR-750/850/751/851
sends another CW ID or CW Message while the CW ID is
independently sent. (Refer to 6.12 CW Message Window.)
6 EDIT MENU
26