Suzuki SWIFT Owner's Manual page 141

CVT models
1) With the gearshift lever in "D" or "N",
depress brake pedal and stop the vehi-
cle.
EXAMPLE
61MM453
EXAMPLE
(1)
2) The ENG A-STOP indicator light (green)
(1) in the instrument cluster will illuminate
and the engine will stop automatically.
NOTICE
The brake booster becomes inoperative
and the pedal effort will increase when
the engine is stopped automatically.
If the vehicle is moving, press down
the brake pedal harder than usual.
NOTE:
The ENG A-STOP system will not operate
and engine does not stop automatically
under the following conditions:
• The ENG A-STOP OFF switch is
pressed to deactivate the ENG A-STOP
system.
• The ENG A-STOP OFF light blinks.
• Engine coolant temperature is either low
or high.
• Vehicle battery performance is low.
• The temperature of the vehicle battery is
either low or high.
• Brake booster vacuum pressure is low.
• Depressing the accelerator pedal.
• Blower speed selector is set to the ON
mode and the inside of the vehicle has
not sufficiently cooled and warmed (for
the vehicle with automatic air condition-
ing).
• The defrost switch is set to the ON mode
57RK105
(for the vehicle with automatic air condi-
tioning).
• During or after the ABS or ESP
is activated, and the vehicle is stopped.
• During the first period use, to initialize
the system.
OPERATING YOUR VEHICLE
• After the engine restarted automatically,
and the vehicle speed had not exceeded
approximately 5 km/h.
• When the engine is started with the hood
open.
• The vehicle has stopped on a steep hill.
• The gearshift lever is in a position other
than "D" or "N".
• When the vehicle has stopped without
depressing the brake pedal.
• The signal to prevent stopping the
engine is received from any electronic
control systems other than the ENG A-
STOP system.
®
system
3-22
57RK0-14E