Table of Contents
Advertisement
Hardware Preparation and Installation
2.12.5
Verify Slot Usage
Product Damage
Prevent possible damage to module components by verifying the proper slot usage
for your configuration.
Check the icons and colored card rails for slot purpose prior to installing a module.
In most cases, connector keying will prevent insertion of a board into an incompatible slot.
However, as an extra precaution, you should be familiar with the glyphs and colored card rails
used to indicate slot purpose.
The following table lists the colors and glyphs common to ECC chassis.
Table 2-4 Slot Usage Indicators
Card Rail
Color
Glyph
Tan
Red
Black
2.12.6
Preserve EMI Compliance
Preserve EMI Compliance
To preserve compliance with applicable standards and regulations for
electromagnetic interference (EMI), during operation all front and rear openings on
the chassis or board face plates must be filled with an appropriate card or covered
with a filler panel. If the EMI barrier is open, devices may cause or be susceptible to
excessive interference.
50
CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Usage
none
MXP: Alarm Management Controller slot
CPX: Hot Swap Controller or Bridge slot
MXP: Fabric Switch Card slot
CPX: System Controller slot
MXP: Payload Card slot
CPX: Non-system Controller or I/O Card slot
Verify Slot Usage
Advertisement
Table of Contents
