Table of Contents
Advertisement
• Align the outside edge (1) of mount bushing with the outside
edge (2) of paint mark as shown in figure.
• Install mount brackets (4) so that its oblong hole side (3)
comes to the rear.
F: Forward
• Tighten stabilizer bar mounting bracket bolts to specified
torque.
Tightening torque
Stabilizer bar mounting bracket bolt:
45 N·m (4.5 kg-m, 32.5 lb-ft)
• Tighten stabilizer bar nuts (1) to specified torque.
Tightening torque
Stabilizer bar nut
(a): 50 – 150 N·m (5.0 – 15.0 kg-m, 36.5 – 108.0 lb-ft)
• Install new split pins (2) as shown.
• Tighten wheel bolts to specified torque.
Tightening torque
Wheel bolt: 95 N·m (9.5 kg-m, 69.0 lb-ft)
Wheel Hub and Steering Knuckle Removal
and Installation
Installation
1) Using special tool and hydraulic press, press-fit wheel hub
(1) into wheel bearing (2) (Face grooved rubber seal side to
wheel hub).
Special tool
(A): 09913-75810
2) Apply grease lightly to contact part (1) of wheel bearing and
drive shaft.
"A": Grease 99000-25050
FRONT SUSPENSION 3D-5
Advertisement
Table of Contents
