Planning Application; Application And Ambient Conditions - Siemens SIMATIC HMI Operating Instructions Manual

Planning application

3.1

Application and ambient conditions

Mechanical and climatic conditions of use
The HMI device is designed for use in a location protected from the effects of the weather.
The conditions of use are compliant with requirements to DIN IEC 60721-3-3:
● Class 3M3 (mechanical requirements)
Tested for
Sinusoidal
vibration,
stationary
Shocks, non-
stationary,
Total shock
response
spectrum
● Class 3K3 (climatic requirements)
Ambient conditions
Air temperature
Relative humidity
Absolute humidity
Atmospheric pressure
Use with additional measures
In the following cases the use of the HMI device requires additional measures:
● In locations with a high degree of ionizing radiation
● In locations with difficult operating conditions, for example due to:
Mobile Panel 277F IWLAN
Operating Instructions, 12/2007, A5E01003940-01
The table applies to the HMI device, charging station and transponder.
Test standard
DIN IEC 60721-3-3
DIN IEC 60721-3-3
The table applies to the HMI device, charging station and transponder.
Permitted range
5 to 40 °C
5 to 85 %,
no condensation
1 to 25 g/m
3
70 to 106 kPa
Comments
Frequency range:
2 ≤ f ≤ 200 Hz
Deflection:
1.5 mm/5 m/s
2
Shock amplitude: 70 g
shock duration: 22 ms
Comments
Corresponds to relative humidity, load
degree 2 in accordance with IEC 61131,
part 2
Corresponds to an elevation of up to
3,000 m
3
51