Transport And Storage Conditions - Siemens SIMATIC HMI Operating Instructions Manual

Safety instructions, standards and notes

2.10 Transport and storage conditions

● 2.0 W/kg within 10 g of tissue (in accordance with ICNIRP guideline)
● 1.6 W/kg within 1 g of tissue (in accordance with IEEE/FCC)
2.10 Transport and storage conditions
Mechanical and climatic transport conditions
The shipping conditions of this HMI device exceed requirements in accordance with IEC
61131-2. The following specifications apply to devices that are shipped and stored in the
original packaging.
The climatic conditions comply with the following standard:
● IEC 60721-3-2, Class 2K4 for transport
The mechanical conditions are compliant with IEC 60721-3-2, Class 2M2.
The following table shows the transport and storage conditions for the HMI device, charging
station, tabletop power supply unit and transponder.
Type of condition
Drop test (in transport package)
Temperature
Atmospheric pressure
Relative humidity
Sinusoidal vibration in accordance with
IEC 60068-2-6
Shock in accordance with IEC 60068-2-29
NOTICE
Device failure
In the following cases, ensure that no moisture (dew) can settle on or in the HMI device,
charging station or transponder:
• Transportation of the HMI device in low temperatures
• Under extreme temperature variations
The HMI device must have acquired room temperature before it is put into operation. Do
not expose the HMI device to direct radiation from a heater in order to warm it up. If dewing
has developed, wait approximately four hours until the HMI device has dried completely
before switching it on.
The following points must be adhered to in order to ensure a fault-free and safe operation of
the HMI device:
48
Permitted range
≤ 1 m
From –20 to +60 °C
From 1,080 hPa to 660 hPa,
corresponds to an elevation –1,000 to 3.500 m
Applies to HMI device:
From 10% to 90%, without condensation
Applies to charging station and transponder
from 35% to 85%, without condensation
5 Hz to 9 Hz: 3.5 mm
9 Hz to 500 Hz: 9.8 m/s
2
250 m/s , 6 ms, 1,000 shocks
2
Operating Instructions, 12/2007, A5E01003940-01
Mobile Panel 277F IWLAN