Installing / Removing The Module - Toshiba G3 Instruction Manual

Chapter 2 Installation and Wiring
2.2

Installing / Removing the Module

GA932 is one slot type module.
GA932 is fixed to the base with the fitting nails at the top of the module and
the mounting screws at the bottom of the module. Turn power OFF before
installing and removing modules.
Procedure for installing
(1) Turn off the power of GA932 module and external power supplied to
(2) Check the installing position of GA932.
Install position: CPU slot of T3/T3H basic base unit.
(The right side of the expansion interface module. Refer to Fig2.1, on
the shaded position)
Expansion interface module
Power module
Expansion module
Expansion interface
Power module
6F8C1590
14
I/O modules.
拡張インタフェース
モジュール
電源モジュール
拡張ケーブル
拡張インタフェース
モジュール
module
電源モジュール
Figure 2.1 GA932 Module Installing Position
・
GA932 module must be installed in the basic
CAUTION
unit.
・
Basic Unit power module and Expansion Unit
power module must use the same power
system.
GA9 32
Base Unit
基本ユニット
G3 I/O module
G3I/O モジュール
Expansion Unit
拡張ユニット
G3 I/O module
G3I/O モジュール
Mandatory