Online Map/Online Status For G3 I/O Module - Toshiba G3 Instruction Manual

Note
• GA932 imports input data of G3I/O, but does not perform output processing for G3 I/O, while
PUM12 is "HALT". Therefore, even when PUM12 is "HALT", the communication module of G3
I/O (Ex. TOSLINE-F10 (MS311)) imports input data captured as G3 I/O, the LED indicating the
reception status may blink.
The reason why G3 I/O transmission module, such as TOSLINE-F10 (MS311), flicks the LED
which indicates the data receiving though the nv controller is halted is described above.
1.1.3

Online map/Online status for G3 I/O module

When G3 I/O transmission module is used, the online map and online status of
the transmission module is entered into the resister of the nv-controller. For the
register configuration, refer to the function manual of each controller.
Table 1-2 Online map/Online status for the transmission module
Refer to "Appendix A.3 G3 I/O Module Support List" about transmission
module to enter online map and online status.
Controller type
type1 light Special register (SW register)
Unified Controller nv series G3 I/O Adapter GA932 Module Instruction Manual
1.1. Functions and Characteristics of GA932 Module
Register type
7