Activating The Battery - Siemens SIPROTEC 5 Operation Manual

!
DANGER
Danger due to device being improperly screw-fastened
Incomplete and careless screw fitting results in death, severe injury, or considerable material
damage!
Ensure that screw-fastening is complete at all intended bolting points. Tighten the screws to a torque
²
of 1.2 Nm.
Produce the holes in the wall to fit the device. The drill holes must be so large that they can accept a
²
screw with a shank diameter of 6 mm.
Produce the holes in the wall to fit the on-site operation panel.
²
Cut a recess into the wall for the connecting cable. The connecting cable links the on-site operation
²
panels to the device.
Place a metallic layer such as a metal plate on the wall if it is not metallic.
²
Fitting the Device
First bolt the bottom fastening screws into the wall.
²
Hook the bottom mounting bracket onto the bottom fastening screws.
²
Align the device in the oblong holes.
²
Screw the device onto the top mounting bracket with the fastening screws.
²
Check for secure attachment of the device on the wall.
²
Installing On-Site Operation Panels
NOTE
i i
Join several on-site operation panels to one another with firm contact. Siemens recommends the use of
contact washers on painted metal assembly walls. If the assembly wall is not metallic, place a metal layer,
for example a metal sheet, between the assembly wall and the on-site operation panel; then connect this
sheet to system ground.
Plug the connecting cable into the on-site operation panel of the basic module.
²
Guide the connecting cable through the cut-out in the wall.
²
Place the 2 contact washers on the top fastening holes.
²
Bolt down the on-site operation panels connected to one another on the wall.
²
Check for secure attachment of the on-site operation panels on the wall.
²

Activating the Battery

3.3.3
Removing the Protective Film
NOTE
i i
The battery is covered with a protective film to protect it from mechanical damage and against premature
discharge.
The battery need not be removed from the battery compartment for activation.
Pull out the battery compartment.
²
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-7, Edition 06.2016
3.3 Surface-Mounting Devices with Detached On-Site Operation Panel
Fitting the Devices
43