Siemens Sitrans PROBE LU Instruction Manual page 81

Product designation
Uniquely identifies the Field Device when combined with the Manufacturer
Identification and Device Type. This variable cannot be modified by the Host user.
Device Serial Num
Uniquely identifies the Field Device. This variable cannot be modified by the Host.
Order No.
The order number for this device.
Date of birth
Date of manufacture.
1.3.1. Software Revision
Corresponds to the firmware embedded in the Field Device.
1.3.2. Loader Revision
Corresponds to the firmware used to update the Field Device.
1.3.3. Hardware Revision
Corresponds to the electronics hardware of the Field Device.
Profile Revision
PROFIBUS PA Profile standard that this device conforms to.
Static Revision No.
The revision level of the static data associated with the Physical Block. The Static
Revision No. is updated whenever a standard profile configuration parameter is
changed.
1.3.4. PROFIBUS Ident Number
Identifies the device on the network. The Ident Number must match that in the
GSD file (the GSD file provides information on the device to the master).
Hand
programmer
values
Installation Date
Date on which the device was installed. The user must enter the date.
Local Operation Enable (default Enabled)
Enables/disables programming the device via the handheld programmer.When
disabled, the user still has access to the mode control of the two Analog Input
Function Blocks.
Go to Identification > Device > Local Operation Enable and select the desired
setting.
7ML19985JB02 SITRANS Probe LU (PROFIBUS PA) – INSTRUCTION MANUAL
0 Profile-specific [uses generic GSD for 2 AIFB (ident# = x9701)]
Manufacturer-specific (uses SMPI DD and GSD file, which
1 *
identifies the Probe LU [PROFIBUS PA]).
128 Profile-specific [uses generic GSD for 1 AIFB (ident# = x9700)]
Page 75