PROGRAM Mode Display
SITRANS Probe LU (PROFIBUS PA) continues to monitor In and Out values even
Note:
when the device is in PROGRAM mode.
3
2
1
4
When you activate PROGRAM mode for the first time in any power cycle, the LCD
displays the first menu. If, during the same power cycle, you switch to RUN mode, and
then back to PROGRAM mode, then the LCD will display the menu or item that was last
accessed in PROGRAM mode.
Security
Local operation enable
Local Operation can be enabled or disabled via PDM (see details under
PROFIBUS address via the handheld programmer
Write locking
Write locking prevents any changes to parameters, either via PDM or the handheld
programmer, but still allows access to the device (see page 76).
Remote operation enable
Remote Operation can be enabled or disabled via the handheld programmer (see
page 45).
Master Reset
Open the menu Device – Master Reset to access the reset options. (See page 46 for
handheld programmer instructions.)
Page 18
SITRANS Probe LU (PROFIBUS PA) – INSTRUCTION MANUAL
1 – Primary region (displays parameter value)
2 – Menu number region (displays Menu number)
3 – PROGRAM mode icon
4 – Secondary region (displays text label)
on page 19).
Setting the
7ML19985JB02