Hitachi Compute Rack 220H Getting Started Manual page 73

Figure A-2: Insert a disk to the tray of internal DVD-ROM
4. Push the tray to close it.
Removing a disc
Reverse the
NOTICE
Lens
Do not touch the eject button when pushing the tray. If you
•
touch the button, the tray cannot be closed. Push the tray
straight. If the tray is pushed obliquely, it may not be closed.
Do not give vibration to the disc in use. It may prevent correct
•
data read.
Remove the disc before turning off the power of the system unit.
•
If power is turned off by mistake with the disc remaining in the
drive, turn on the power again, wait until the system unit starts
up, and then remove the disc.
If the drive has been broken and the tray cannot be ejected with
•
the eject button, turn off the power and insert a thin pin or the
like into the manual eject hole to eject the tray and remove the
disc. When you take manual eject, be careful dust does not
invade through the hole.
Inserting a disc
Do not auto eject or remote eject the disc while a front bezel is attached
or the front door of the rack cabinet is closed. Do not attach a front bezel
or close the front door of the rack cabinet while the tray is open.
The tray can interfere with the front bezel or the front door and can
cause a failure.
Hitachi Compute Rack 220H Getting Started Guide
Latch
procedure.
Appendix A-3