Removing the system unit
This section describes how to remove the system unit from a rack cabinet.
Unmounting the system unit to the rack cabinet
The following describes the procedure to unmount the system unit to the rack
cabinet.
1. Disconnect all the cables from the system unit.
See
Connecting to the system unit
2. Remove an optional front bezel (AU7705–Y/AU7705-R) if any.
See
Removing a front bezel
3. Slide out the system unit while pressing the buttons on the inner rails until
the inner rails stop.
Then the inner rails are locked by lock latches (White).
4. Further slide out the system unit while pulling the lock latches (White) and
disengage the system unit.
Lift the front of the system unit slightly when sliding out the
•
system unit. Otherwise, the system unit can interfere with
another unit installed below, which may cause those units to be
deformed.
Do not push down the system unit while sliding out the system
•
unit. If you do, the system unit may be deformed.
Installation
Hitachi Compute Rack 220H Getting Started Guide
on page 3-9.
on page 3-8.
3-17