Connecting To The System Unit - Hitachi Compute Rack 220H Getting Started Manual

Connecting to the system unit

This chapter describes how to connect peripherals to the system unit.
Computer display, keyboard, and mouse
Connect the computer display to the VGA connector on the rear side of the
system unit using a display interface cable. Connect a keyboard and a mouse to
the USB connectors (rear side). Then connect the power plug of the computer
display to the electrical outlet box inside the rack cabinet or an uninterruptible
power supply (UPS).
Figure 3-9: Connecting display, keyboard, and mouse
At the first startup after you change the configuration of the system
unit, Windows loads new drivers and sets up new services. Because the
USB driver is not loaded during this period, you cannot temporarily use
a keyboard and a mouse for input.
If you changed the configuration of the system unit, wait one or two
minutes after startup and then use the keyboard or mouse for input.
Hitachi Compute Rack 220H Getting Started Guide
Installation 3-9