Settings For Connecting To Ts-890S - Kenwood TS-890S Setting Manual

27

4.3.3. Settings for connecting to TS-890S

Follow the procedure below to make settings for connecting to TS-890S.
After starting the ARCP-890, select "Settings" in the "Tool" menu, then the "Settings"
window opens.
Tips:
When ARCP-890 is started for the first time, the "Initial Setting" window opens and you can
make settings for connecting to TS-890S.
Fig. 4.3: "Settings" window
As shown in the above figure, select "KNS (KENWOOD NETWORK COMMAND SYSTEM)
(Directly to TS-890S)" in "Connection to TS-890S".
Next, to set the information such as the IP address of the TS-890S of the connection
destination, click "Setting" button. The "Configure KNS (Directly to TS-890S) Connection"
window below opens.