Configuration Of The Input Path Of Tx Audio; Setting And Confirming The Ip Address; Confirming The Global Ip Address - Kenwood TS-890S Setting Manual

4.2.9. Configuration of the Input Path of TX Audio

When remotely operating with Internet connection, the audio for transmission is input from
the LAN connector by VoIP. In order to transmit audio from the LAN connector by the
transmission operation from the ARCP-890, set the DATA SEND audio input from the rear
panel to "LAN" on the "Modulation Source" screen of the TS-890S. (See the screen below)
Fig. 4.2: Configuration of the Input Path of TX Audio
Also, in order to prevent unintentional transmission during remote control by KNS, set DATA
VOX normally select "Off".
(Note) The "Modulation Source" screen shown in Figure 4.2 can be set separately for DATA
mode Off and DATA mode On. Please set according to the operation mode.

4.2.10. Setting and confirming the IP address

Set the IP address required for operation in the network environment. The IP address setting
includes automatic setting (using DHCP) and manual setting.
The IP address is set in the LAN menu of the TS-890S. For the operation method, refer to
the operation manual of the TS-890S.
Since the IP address of the TS-890S is required when setting up the host station 's
broadband router, confirm the IP address set above. For details on setting to the broadband
router, please refer to chapter "4.4.2. Broadband router settings".

4.2.11. Confirming the global IP address

Since the global IP address of host station side is required when setting up the remote
25