Siemens Gigaset 2420 System User Manual page 10

These appliances may cause electrical interference. For more information on appropriate locations, see the
Important Safety Instructions section of this manual.
Your desk station must be placed on a hard, flat surface and connected to both a phone wall jack and an AC power
outlet.
Use within a temperature range of 32 to 120 F.
3. Locate the desk station's AC power
cord. Plug the power supply into a
functional 120 vat electrical outlet.
The outlet should not be controlled
by a wail switch.
3. Turn the desk station over, be careful not to bend the antenna. Thread the desk station's AC power cord into Cord
Channel 3 and snap the plug into the telephone jack labeled 12V DC @ 4Ooma
2
4. You must purchase two lines from the telephone company in order to have two line access. These lines do not need to be
physically separate, i.e., exist as two wires with two separate jacks. The telephone company can set up two separate lines
using the same jack. These lines can be shared with other telephones in your home or office.
Note: If you only have one line and that line is busy, phone calls will be routed to your nonexistent second line unless you
set the Trunk Access option described in Chapter 7 Customizing Your System to Line 1 Only.
Note: Your desk station and cordless handsets can share a line with a non-Gigaset 2420 telephone system, but calls on the
shared line may be interrupted by the non~system phone. You can prevent Gigaset 2420 phones from interrupting active
calls on the non-system phone by setting the Call Barge In feature. See System Settings in Chapter 7 Customizing Your
System for more information.
• If you have two lines
same jack or if you have only one line, you can use
the standard telephone line cord.
a. Insert the standard telephone line cord into Cord Channel 1. Snap the plug into the telephone jack on the bottom
of the desk station labeled Lines 1 & 2 as illustrated on page 2.
b. Snap the other end of the telephone line cord into a wall jack.
•
if you have two physically
separate lines, use
a. Insert the long end of the Y telephone line cord into Cord Channel 1 and snap the plug into the
Chapter • •
Installation
Chapter • • Installation
using the
the Y telephone line cord.
Page 2
page 3